TE0701 Carrier Board

Overview

Trenz Electronic TE0701 is the baseboard circuit board for all TE07xx modules.  This board interconnects one Trenz Electronic TE0720 / TE0710 / TE0712 / TE0741 module to a variety of I/O, including an LPC FMC card.

Specifications

• Trenz 4x5 Module Socket (3x Samtec connectors)
• RJ45 GbE Ethernet
• MicroUSB Connector (Device, Host or OTG Modes)
• SD Card connector - Zynq SDIO0 Bootable SD port
• Pmod Connector A, 3.3V
  • 6 Pins can be multiplexed to SD Card pins (MIO1 bank when using TE0720)
  • 2 Pins connected to Carrier Controller CPLD
• Pmod Connector B, 3.3V
  • mapped to 8 PS MIO0 pins if using TE0720 (same mapping as on zedboard)
  • 6 Pins also connected to Carrier Controller CPLD
• Single 12V Power supply
• High Performance Enpirion DCDC converter for local supplies
• VITA57.1 compliant FMC LPC Connector
  • Digitally programmable FMC VADJ Power Supply
• Carrier Controller CPLD
  • 1200 Macrocell CPLD with Block RAM, Flash and PLL
  • 8 User LEDs mappable to different functions
  • 2 User Pushbuttons mappable to different functions
  • VID and EN control for FMC VADJ DCDC Regulator
• USB JTAG Interface
  • mini USB connector
  • Compatible with Xilinx tools: Impact, Chipscope, XMD, Vivado/SDK etc..
  • Compatible with OpenOCD debugger including ZYNQ SRST control
  • Based on FT2232H USB chip
  • Channel A can toggle Module (ZYNQ PS) Reset
  • Channel B can be used as USB UART
    • Carrier Controller can reroute RXD/TXD signals
  • JTAG Port can be connected to (by the Carrier Controller)
    • 4x5 Module JTAG (FPGA + ARM chained in Zynq)
    • 4x5 Module JTAG and FMC JTAG in chain
    • FMC JTAG alone
    • Zynq ARM PS JTAG port (via EMIO muxing in TE0720)
    • 6 Pin header for off board use
    • Pmod Connector B for off-board use

Package Contents

• 1 x TE0701-06 Carrier Board for Trenz Electronic modules with 4 x 5 cm standard footprint only

Available Models

Pricing, Availability and Ordering

• Concurrent EDA is the US Distributor for Trenz Electronic FPGA Micromodules.
• Please email Ray at This email address is being protected from spambots. You need JavaScript enabled to view it. for pricing and availability.